Tiegel home Talk to a metallurgist

Merrill-Crowe zinc precipitation: process steps and calculations

How Merrill-Crowe recovers gold and silver from cyanide solution with zinc dust: clarification, deaeration, zinc dosing and precipitation efficiency.

· 4 minute read · By

Zinc is more reactive than gold, so when zinc dust is added to a gold cyanide solution the zinc dissolves and the gold is precipitated as fine metal. Merrill and Crowe developed this into a continuous process more than a century ago, and it remains in use. Merrill-Crowe and carbon adsorption are the two principal methods of recovering gold from cyanide solution. This article describes the process steps, the chemistry and the calculations used to operate and check the process, with a worked example.

Merrill-Crowe flowsheetPregnant solution is clarified, deaerated in a vacuum tower, dosed with zinc dust and lead nitrate, and filtered; the precipitate is smelted.PregnantsolutionClarifierfiltersVacuumdeaerationZinc dust +lead nitratePrecipitatefilter pressBarren solutionback to leachprecipitate to smelting
Merrill-Crowe. Clear, oxygen-free solution is the key: suspended solids blind the filter and dissolved oxygen wastes zinc.

Process steps

  1. Clarification. Pregnant solution from a counter-current decantation circuit, filters or a heap leach pad is filtered to remove suspended solids, typically through leaf or precoat filters, with turbidity monitored continuously.
  2. Deaeration. The clarified solution passes through a vacuum tower packed with media that spread it into thin films, allowing dissolved oxygen to escape. The target is a very low dissolved oxygen level; the plant's own data show the level below which zinc consumption and gold in barren solution remain low.
  3. Zinc dust and lead nitrate addition. Fine zinc dust is fed into the deaerated solution, usually as a slurry from an emulsion cone. A small addition of lead nitrate deposits lead on the zinc and accelerates the reaction. Free cyanide must be high enough to keep the zinc dissolving.
  4. Precipitate filtration. A filter press, often precoated with diatomaceous earth, collects the gold, silver, excess zinc and other precipitates. The filtered barren solution returns to the leach.
  5. Refining. The precipitate is dried, often treated with acid or calcined to remove zinc, and smelted to doré.

Chemistry and stoichiometry

2Au(CN)2−+Zn→2Au+Zn(CN)42−ZnAu=65.382×196.97=0.166 g zinc per g gold

where

Au(CN)2−
gold cyanide complex in the pregnant solution
Zn
zinc dust

Silver precipitates in the same way. In practice zinc also reacts with water and with any remaining oxygen, and the zinc must provide sufficient surface area for a fast reaction, so plants add far more zinc than the stoichiometric quantity.

Worked example

A plant treats 150 m³/h of clarified pregnant solution containing 3.0 mg/L gold. Barren solution after the precipitate press assays 0.01 mg/L.

Gold entering the process is 150 × 3.0 = 450 g/h, and the stoichiometric zinc requirement is 450 × 0.166 = 75 g/h. Zinc added at 15 g/m³ of solution, the plant's set point in this example, is 150 × 15 = 2,250 g/h: five times the mass of gold and about 30 times the stoichiometric quantity.

precipitation efficiency=Cin−CoutCin

where

Cin, Cout
gold in the clarified pregnant solution and in the barren solution after the precipitate filter (mg/L)

Precipitation efficiency = (3.0 − 0.01) ÷ 3.0 = 99.7%. The gold remaining in barren solution, 1.5 g/h, returns to the leach rather than being lost, provided the barren solution is recycled.

Zinc used against zinc needed by the reactionThe reaction needs 75 g of zinc per hour to precipitate 450 g of gold; the plant in the example adds 2,250 g/h.01,0002,000Stoichiometric zinc: 75 g/h75 g/hStoichiometric zincZinc added in example: 2,250 g/h2,250 g/hZinc added in exampleZinc (g/h)
Zinc is added in large excess because it also reacts with residual oxygen and water, and needs surface area for fast precipitation. Illustrative figures.

Process monitoring

Feed solution clarity is essential, because suspended solids coat the zinc and blind the precipitate press. Dissolved oxygen after the vacuum tower should be monitored closely, since rising oxygen increases zinc consumption and gold in barren solution. Free cyanide and pH must be maintained, because insufficient cyanide allows zinc hydroxide or zinc cyanide to coat the zinc particles and stop the reaction.

Gold and silver in barren solution, sampled every shift, are the direct measure of performance. The zinc-to-gold ratio and the precipitate grade should also be tracked, because excess zinc dilutes the precipitate and increases refining cost.

Merrill-Crowe compared with carbon adsorption

Carbon adsorption (CIL and CIP) dominates gold milling because it operates directly in slurry and tolerates lower solution grades. Merrill-Crowe is preferred where solutions carry much more silver than gold, since carbon would be loaded mainly with silver; for clear solutions such as heap leach and counter-current decantation liquor; and where the ore contains materials that foul carbon. Our article on activated carbon testing covers the carbon route.

Glossary

Pregnant solution
Cyanide solution carrying dissolved gold and silver.
Barren solution
Solution after the gold has been removed, returned to the leach.
Clarification
Filtering out suspended solids so the solution is clear.
Deaeration
Removing dissolved oxygen under vacuum.
Zinc dust
Very fine zinc powder used to precipitate gold and silver.
Lead nitrate
A small addition that coats zinc with lead and speeds precipitation.
Precipitate
The solid gold, silver, zinc and other metals collected on the filter press.
Counter-current decantation
A series of thickeners that washes leached solids with solution flowing the opposite way.

Frequently asked questions

How much zinc is needed per gram of gold?

The reaction requires 0.166 g of zinc per gram of gold, but plants add many times more because zinc also reacts with water and oxygen. The appropriate dose is established from plant performance.

Why must the solution be deaerated before Merrill-Crowe?

Dissolved oxygen consumes zinc and can redissolve precipitated gold, increasing both zinc consumption and gold in barren solution.

What is the purpose of lead nitrate in Merrill-Crowe?

Lead deposited on the zinc surface makes the reaction faster and more complete.

When is Merrill-Crowe preferred to carbon?

When silver is high relative to gold, when the solution is already clear, as in heap leaching, or when the ore fouls carbon.

Discuss your plant with a metallurgist

Tiegel is a Perth metallurgy company. We help with testwork, plant optimisation, metal accounting and investigations, and we build the Tiegel Suite software.

Talk to a metallurgist

References and further reading

  1. Marsden, J.O. and House, C.I. (2006). The Chemistry of Gold Extraction, 2nd edition. Society for Mining, Metallurgy and Exploration.
  2. Wills, B.A. and Finch, J.A. (2016). Wills' Mineral Processing Technology, 8th edition. Butterworth-Heinemann.

Worked examples and charts marked illustrative use invented figures, not data from any operation.